Riflehunter
Members-
Content Count
60 -
Joined
-
Last visited
About Riflehunter
-
Rank
Member
Recent Profile Visitors
2,838 profile views
-
I'll take the 38/357 dies if available. Pm sent
-
I'm not sure if they plan to do a run of 270wsm at some point but Lapua just announced they will now be doing 300wsm this spring.
-
As a former ag mechanic I ran alot of matco mac and snapon but did use some older craftsman, gearwrench ratchet wrenches and alot of my 1/4" drive stuff was also gear wrench. Alot of my bigger sockets were grey pneumatic which are pretty decent for the money. The normal tool trucks do usually run specials on stuff as well.
-
Pm sent
-
Loose primer pockets
Riflehunter replied to bowhunter-tw's topic in Rifles, Reloading and Gunsmithing
I have seen loose primer pockets on federal brass in 7mm rem mag as well as my 300wsm. Some of each caliber had loose primer pockets after firing the factory loaded ammo. So they were loose after 1 single firing from factory loaded ammo and some i got 1 load out of them, now if i end up with fed mag brass i just throw it in my scrap brass bucket. I use the ballistic tools primer pocket go/no-go gauges for all of my rifle brass as well. Great for a quick check after decapping. -
Basically new camp chef oven/stove Combo. Hasn't been used in a couple years. Asking $180 Cody 480-694-7450
-
I'll take then if it falls through. Work in chandler
-
I'll take 2nds on the dillon if it falls through for some reason. Pm
-
Outdoorsman’s Rifle Chassis system for sale
Riflehunter replied to ProSlayer's topic in Classified Ads
Pm sent -
**SOLD**Zero Tolerance Knife: Price Drop**SOLD**
Riflehunter replied to Azhockeycoach's topic in Classified Ads
I'll take 2nds on the 0350 if it falls through.