S&B PMII 5-20×50 Ultra Short

[lancetkenyon]

Does anyone in town have one of these?  I am on the fence about buying one for my new build, but not sure it will fit.

Going on a Lone Peak Fuzion TI SA with 2 piece integrated rail.  I have another one that I can test fit it on.  Has to be in rings, not a Spuhr type 1 piece mount.

I will bring the tools to retorque after the test fit.  Should take 10 minutes or less.

[yotebuster]

I’ve got a 3-20.  But I’m in ND so I’m essentially worthless.  I could send it down.  Not sure if the dimensions are the same.  

[lancetkenyon]

I have a 3-20×50US too.  Totally different scope body though.  I appreciate the offer.  Super nice of you.

 

[lancetkenyon]

Well, I pulled the trigger on it.  Got it last night, rings should be here Monday.  It should fit just fine though.

[yotebuster]

Let’s see a pic when you get it set up!!  I just shipped one of my 3-20’s to my smith to go on a muzzleloader.  Just might have the worlds most expensive muzzy before it’s all said and done!  Why did you go with the 5-20 over a 3-20?  Is it more compact?

[lancetkenyon]

Yes, it is shorter and also lighter by a few ounces.  

Once my rings get here on Monday, I will mount it up on my 6CM which is the same action as my new one I am building.  I will take some side by sides next to my 3-20US.

[lancetkenyon]

Need some side by sides, but here it is mounted up.  Not the rifle it will stay on, but same action and barrel.

Close fit for sure.  

Compared to a 3-20×50 Ultra Short

[grunt]

That rifle is bad to the bone!