Zeke-BE

Oh awesome pic and congrats on your hunt!!!!

I did a New Mexico hunt this year with a guide, but I really want to do a DIY trip in Wyoming. Any tip on what unit to pick and easy access to state land? Also can't you get more than 1 buck tag? I took average joe advice and bought a point.

Money for Glassing deer. That's a great idea. I think there needs to be a limit after the 3 rd year

Squirrel was my first kill as a kid

Those are great!

You got one good spot!!!!'

Depends on the area. If i am in a location where I only have less then a 180 degrees from side to side and less then 800 yards I'll move more often or just go over the other side of the ridge and glass. If I got more than 180 degrees from side to side and a mile out its very common to stay there for hours in one spot. Depending on some spots and landscape I've brought in lawn chairs and a few sodas and glasses very comfortable for a few hours

Couse 7 I never thought about Glassing the shadows in the morning. I always did that when it warmed up. I'm keeping a mental note of that. My advise is what everybody has said. Then one more advise for the October hunts I've been in 100 degree weather before and wonderful cool weather. But when it stays hot I did notice during the morning at the base of the mountains, in ravines or small canyons ( Physics) that cold air would settle down there and I would find groups of deers up to 10 bedded down there, bucks as well. Every hot hunt it was like that. When you did make your way through it, it was really nice and cool.

I've been hunting quail by the black mountain for over a decade. I have not once seen a pig. Seen tracks and smelled them before. This is mainly on the north side. I never remember the name of the areas really well but on the east side of black mountain you will see a radio tower. Just east of that I got into some heavy quail and found some abandon mines with hundreds of piggy tracks. I kept a mental note of that area and when I left and open the gate I realize there is no trespassing sign on the ground which would make since why the quail were so easy. The next year I went back there were brand new signs and very clear postings of no trespassing. Maybe Hoover around the ranch property and maybe you will find one around there. I believe this is the same direction snapshot is talking about.

I am assuming this is at 100 yards right! 2-3 inches is a lot. Are you shooting from a sled/ stand or is it off your shoulder and tri pod? When I shoot from the shoulder on a tri pod or bag I'll be in 2-3 in grouping at 100 and be around 3-4 at 200'yards. I'm not the most advid shooter but that's what I get shooting off the shoulder. Off the sled strapped down I'll be an 1" or less. If you are using the sled maybe your mounts are not totally tighten down. That my guess. I'm new to loading so I have no advice with the powder. Good luck

He said he is going into the wilderness. Queen valley and peralta aren't in the wilderness. If he was to hike in to the wilderness from there, he would be in deer country. South of Tucson brings a new set of considerations to the table for somebody who is not familiar with the border. No one even mentioned 37b, and since he specifically mentioned coues in the wilderness I don't think you have anything to worry about. No need to try and protect your spots from this non-scouter. Flatlander it sounds like I stuck a nerve with your 24 b unit if you got to point out all my flaws. I was just pointing out other options if his wilderness adventure doesn't work out and have to hunt closer to towns. If I was going out of town I would at least have a plan B. The only wilderness I've hunt is 24b. But if we can't make it in for whatever reason he can still hunt other parts of the units that doesn't involve a bunch a quads which is right next to the wilderness ( Queens valley area). I'll try to be a little more specific next time.

For a unit to just show up 24 b is not the choice for you. It has a lot of deer and it's a great unit if you know the spots to hit. Stay away from queen valley and peralta trail. It's full of weekend warriors quad and target shooters. If you do do that unit and want to head to a ( spot ) that doesn't need much scouting and just show up back pack into the wilderness. If you head south of Tucson most of those units you can pick a area and do ok. If you don't care if it's couse or mule hang out at the base of the mountains you will get a mix of mule and couse deer. Find a ridge and glass the flats and turn around and glass the slops. Stay away from 37b. That is a unit only for hunters who put the time into scouting. Good luck

I've seen lots of good spots on these trail cameras. Lots of good areas with seep holes. I'm just curious how many miles are you guys putting on the boots to find these spots or am I not alone in struggling in finding a spot and should just stick to what i know which is Glassing and Glassing?

Murphy's law! But great pics

I hate theifs!!! I always wanted to come across someone else's cameras moon them and turn around with a thumbs up ha ha. But taking stuff that's not yours come on!

Ok lancetkeyon I got some new information. I went out today to mess around with new loads. But something's are still off but it might not matter if I like the loads. My last velocity on those round that I started with on the forum were slow but my brothers factory Winchester round shooting 150 grain vs my 140 grain was shooting 2780 ft to 2800 fps. So we pulled one of his rounds apart and it weighed 47 grains of what it looks like Winchester powder (the small BBs type). My buddy had some W760 and loaded 53 grain max on the nosler book and I got 3000 fps and the book says 3018 (close enough) and we up one to 54 grains and got 3064 fps but the bolt got sticky and bulge the primer, so I stopped right away. Then I retried the H4831sc which we had a mistake and loaded it to the max of the IMR 4831 (which is 53.5 grains). This explains why that load was so slow. But it still doesn't add up to well. I shot the Max load according to Nosler Book at 58 grains. The book says 3000 fps but I got 2810 fps. I then shot a Winchester brass of what you said Lance earlier but it shot 90 fps slower. I cant be sure exactly I didn't load to many Winchester brass. Then I loaded the 4831 up to 59 grains and got 2850 fps, then loaded 60.5 grains and got 2945 fps, my brass is almost topped out but it showed no sign of wear on the brass and no sticky bolt. Lance with your H4831sc you have 57.5 grains and shooting 2900 fps and shooting the 150 grain bullet and still passing my 140 grain accubond. Could this be truly the brass for this cause?? Or primer? I haven't tried a different primer yet. My brain starting to hurt!! Also if my W760 works out I might go with that. I have never used it before so does any one have any experience on that Powder???

Thanks Mill house, I did read 5:30 mountain time but your right it's midnight. So I got one!

I followed your link Average Joe. One problem about the points. To buy a bonus point it ended 30 minutes, maybe a little longer since it is on Mountain time. Bummer !!!!!!!

I have the Tikka T 3 in a 270. The gun is light weight and I have a Limbsaver on it. Feels good in the hand and the bolt is very smooth. The savage to me feels cheap, but there is lots of up grades for them. In the end shooting a deer to 100 yards to 200 yards with a cheap brand or a high end brand it's going to do the job just fine. If you are going switch his gun out in the future just get him the .243. If a long term gun get the 7mm 08. Personally I just want to get both!!!!

Everybody I talk to has 20-25 points and I got 4 Measly points, so i opt out and went to New Mexcio this year at the end of August So now I got one!!!! It was a lot of fun and now I'm investagsting wyoming. If you can shed any more details to start that would be awesome.

They do overlap a lot! I used to bow hunt that area and whatever type of breed of buck stepped in front of me I was willing to take a shot at him. I've seen couse from apache lake all the way up to globe. Pick an area and Glass Glass Glass

It's very realistic to just scout from the computer show up, glass and find bucks. I've done it many times do to work, or f Financial reasons when I couldn't make it out scouting. Two years agos I couldn't do any scouting and showed up 2 hours late opening morning and just pick a good ridge. After an hour I got onto a nice 95" buck but messed up on the shot. But everybody is right just Glass and Glass!!

According to my Nosler book, your loads are a far cry from published velocities. You are using their preferred primers (Fed 210 LR), but you never mentioned case brand/head stamp. They loaded with Winchester cases. If you use a different case, it could have different capacity, causing either lower pressure/lower velocity, or high pressure/higher velocities.47.0gr. RL15 (published max) should net you about 2832fps.53.5gr. IMR4350 is over published max load of 52.5 which should net you about 2858fps, so your load should be even hotter.55.0gr. RL19 (published max) should net you about 3003fps.These are all book loads, so take them for what they are worth as far as "Max". Books are usually very safe on what they will publish as a max load for liability reasons. My head case/ stamp which I believe you are talking about the brass, is Nosler ( I'm still new to reloading). I have it set at 3.330 which barley fits in my Tika magazine, which slightly pushes back as I chamber it . But I do apologize my buddy wrote down IMR 4350. It was loaded H4831c. But I don't remember if we loaded it to the max at the H4831 or loaded it at the IMR. If we did load it at the max for the IMR I would be almost 4 grains short for the H4831. I'll take one apart and weigh it. But my other powders are according to the Nosler Book.

That was my idea. Can changing a primer change the speed up to 1-200 fps faster?

I haven't seen a place to shoot dove off of Ellsworth for years. You must be packing it in somewhere?