bowhunter-tw

Ttt

Ttt

Mags sold.

What does it weigh?

Updated prices. Open to offers

Price drop $600

Ttt open to offers

Ttt open to offers

Right about 4lbs

Did you catch them on camera?

I have done this! Works well enough for now! Does it make sense to anneal before or after sizing? After would relieve work hardening stress after sizing but before would probably prevent splitting?

Up

Up

Up

Up

Up

An annealer is one of the last pieces of reloading equipment ive yet to get

Pressed a fed primer into a case, went in with expected amount of tension vs the win primers. Maybe the brass isnt over pressured its the primer size

I just measured random pieces of once fired brass from low end loads to the upper end, factory once fired, and factory loaded ammo. All the once fired brass measures within .0002”-.0003” of each other at both the belt and in front of the belt. But from the factory new ammo vs any once fired the case right before the belt has grown .005” no matter the load?

If it does just need a turbo, kc turbos are sweet. Im running one in my 7.3, just a little over sized than stock, made a huge difference.

All the brass I have is once fired, but not in my chamber. When you say at the belt do you mean the diameter of the belt or diameter right above the belt where the case meets the belt?

Ive got some norma brass I can use. Should I seat the bullets a little deeper? Im seating them a little long of the cannelure (about .010-.015 short of it) I was going to back off a grain an see how that looked

Im thinking a .215 pin might work? I can 3d print a new head to fit whatever pin I need to use

Wouldnt RL23 be pretty close in burn rate to 7828?