Bill V
-
Content Count
209 -
Joined
-
Last visited
Everything posted by Bill V
-
FS: Leupold VX-3i, 4.5-14x40mm, Boone & Crockett Reticle
Bill V replied to Lucafu1's topic in Classified Ads
Photos? -
Ruger #1 .270 - beautiful custom rifle - Offers considered
Bill V replied to geologger's topic in Classified Ads
Who did the stnck and metalwork on this rifle? -
Tough crowd here!🤣
-
Location?
-
I have a Tikka t3x superlite that needs taming. Looking for recommendations for a smith to thread and install a brake. This is on a stainless barrel and would like it blended into the oem taper and a cap furnished. The barrel at the muzzle measures .635 and is a .277 bore. Let me know who you recommend. Thanks, Bill
-
Thanks to everyone who responded. Now I need to find one somewhat close and not slammed with work. I appreciate those that took time to answer. CWT always comes thru. Bill
-
Mike, sending you a PM.
-
Excellent Plus condition Rock Chucker press. Ram is smooth as glass. Comes with original paper and an extra primer arm set up for small primers. I am upgrading so need to make room. A very nice press for $75. I live near the 303 and Happy Valley in Peoria. I can send more photos to those interested. 602 three 7 six - 1 five 98. Thanks, Bill
-
Photo added.
-
Rock Chucker Supreme.
-
Yes, found. Arranging to meet Lionhunter. Thanks for your response
-
Just that. I have an empty bottle and a scale if from bulk. I live in Peoria but willing to drive within reason. Message me. Thanks, Bill
-
PM sent.
-
PM sent
-
Location?
-
Free to anyone who can use this new in box 2 cavity mold. #82034 in 38/357 158 gr round nose. These retail in the $150 range. I live in Peoria, 602 Three 7 six-one 5 nine 8 Bill
-
PM sent
-
Sorry, I don't want to ship. Pick up at my front door. Thanks Bill
-
ttt
-
Free
-
Westinghouse gas power washer 3400psi and 2.6 gpm. Used two times to clean my BBQ and drive. Starts easily and performs as it should. Comes with two complete sets of nozzles and a 90 degree for washing under vehicles. Home Depot sells these for about $365 with tax, Save big at $195. Thanks for looking. I live in Peoria, 602 Three 7 six-one 5 nine 8 Bill
-
TTT
-
I had this problem with a 270. I tried different dies, hard bumps, long delays while sizing and all to no avail. I finally reduced a RCBS shell holder from 0.501 to 0.495 and the problem was solved. May not work for everyone but might be worth a try. Bill
-
83 - 85" Lot of mass above the prongs
-
I will pay $80 cash money if trade falls thru. In case you decide to sell. Offer goes to anyone else that has a pound of RL26. Bill
