Couzer

Ha ha giving me way to much credit

I'm no expert, but I don't think so. I'll just know if they are my shell casings if a crime is committed.

Expander Die for the straight wall cartridge. Just be careful not to open/bell it out to much. "Expander Die expands the case to the proper diameter to accept the bullet, and it imparts case mouth flare/bell for bullet feeding."

It would most likely be in the recoil when shooting rather than feeding them. Hornady said the FTX red polymer tips are ok, i just wouldn't use other brands unless they say they are good to go.

Found some

I know the red tip polymer one looks cool but to my knowledge hornady is the only one I know that makes one "FTX" that's safe for the magazine tube if you go that route. Due to the tip resting on the primer stacked in the tube. I have loaded them for my 357 lever, but if I remember I had to trim the brass more than a standard 357 measurement. Not sure if that's the case on the 45-70.

My supplier accidentally sent me 45-90, I needed them so I cut them to 45-70.

.458

Any new brass will work, it seems like Starline always has something available. To me it is worth reloading just because I found 350 grn projectiles for next to nothing. One thing you need to know is if you have a lever action is to make sure you have a proper crimp. This task can be daunting if you never done it. I loaded a couple hundred rounds a few months back with awesome results, 4" group at 100 yards with iron sights with 3 shoots almost touching out of 4. If your in the East Valley I can help if needed.

Meh, first you had the 7mm, then the 7wsm, then the 7 saum, then 28 nosler, then 7prc then 7 BC,,,,, lol all good. I was that guy that had to have the newest and greatest. I absolutely love the first, 7mm remington mag.

$50-$100 maybe to someone?

Add LEM Vaccum sealer

Sounds good!

Sold the stock

Added 22 hornet

Im down to 213lbs from 240lbs in about 2 months. Still dropping, glad I'm done with the holidays.

Top

I need one to, been looking for a while.

Top, Model Seven Stock added.

Lead

Added powder

Just had him at the house today.

All good, ya i just had someone pick up the cast stuff. Figured I'd kill 2 birds at once.

2715 E Ocotillo Rd, San Tan Valley, AZ 85140 Cast Iron just sold