catclaw Report post Posted 10 hours ago I replaced my lathe with a different one. I don't have room for 2. I've chambered many dozen barrels on this Nardini. It's well tooled, 3 chucks. Chambered a barrel Saturday.- the farewell send-off for a great lathe. I put it here first before it goes in there usual places. A PM works. Lathe is in Mesa $3000 Share this post Link to post Share on other sites
AZ7maghunter Report post Posted 10 hours ago @Rubberduckie Share this post Link to post Share on other sites
Azshooter Report post Posted 4 hours ago bump for a good guy Share this post Link to post Share on other sites
Anozira Report post Posted 58 minutes ago What wiring is it set up for? 3 phase? Share this post Link to post Share on other sites
catclaw Report post Posted 57 minutes ago It is 3 phase. Share this post Link to post Share on other sites
GSPMan Report post Posted 54 minutes ago catclaw is legit. Deal in confidence. Great deal here. Share this post Link to post Share on other sites
Anozira Report post Posted 52 minutes ago I can't tell from the picture, does it happen to be a gap bed? Share this post Link to post Share on other sites
