catclaw Report post Posted Wednesday at 04:09 AM I replaced my lathe with a different one. I don't have room for 2. I've chambered many dozen barrels on this Nardini. It's well tooled, 3 chucks. Chambered a barrel Saturday.- the farewell send-off for a great lathe. I put it here first before it goes in there usual places. A PM works. Lathe is in Mesa $3000 Share this post Link to post Share on other sites
AZ7maghunter Report post Posted Wednesday at 04:19 AM @Rubberduckie 1 Share this post Link to post Share on other sites
Azshooter Report post Posted Wednesday at 10:49 AM bump for a good guy Share this post Link to post Share on other sites
Anozira Report post Posted Wednesday at 02:05 PM What wiring is it set up for? 3 phase? Share this post Link to post Share on other sites
catclaw Report post Posted Wednesday at 02:06 PM It is 3 phase. Share this post Link to post Share on other sites
GSPMan Report post Posted Wednesday at 02:09 PM catclaw is legit. Deal in confidence. Great deal here. Share this post Link to post Share on other sites
Anozira Report post Posted Wednesday at 02:10 PM I can't tell from the picture, does it happen to be a gap bed? Share this post Link to post Share on other sites
catclaw Report post Posted Wednesday at 09:59 PM Yes Share this post Link to post Share on other sites
catclaw Report post Posted Wednesday at 10:01 PM But I doubt the gap has ever been out.i have some face plates of you're a gap bed kinda user .also had taper attachment Share this post Link to post Share on other sites
